Hi
I have another question about a slow System.
I have to GET documents out of an Applikation and load it again into a new one.
x.ind
x.out
x.res
On the Test System it takes less then 10 sec for 3 loads if I do it the same on the Prod it takes almost 9 min
Also if I take a look at this Documents it takes a long time till they show up ...
It's on a RHAT 8.0/Oracle and the performance was ok so far.
I am searching all over to find the reason .... no luck
If I have the ARS_NUM_DBSRVR=100 < Is this to high ?
d/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB-p | wc -l`
arssockd count: 111
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
arssockd count: 111
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
arssockd count: 111
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
arssockd count: 116
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
arssockd count: 115
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
arssockd count: 111
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
arssockd count: 111
nd/V10.5/bin $ echo `date` arssockd count: `arssockd -I DB -p | wc -l`
Spectrum Protect is working and Storage S3 should also not be the problem because there where no changes done.
regards dani